![]() ![]() If you use the /t option, you must also use the /n option. When possible, use the /f command-line option instead. Specifies the number of tracks on the disk. ![]() 1.44-MB, double-sided, quadruple-density, 3.5-inch disk.Windows accepts the following values for size: When possible, use this command-line option instead of the /t and /n command-line options. Specifies the size of the floppy disk to format. You should use the /q command-line option to format only previously formatted volumes that you know are in good condition. Deletes the file table and the root directory of a previously formatted volume, but does not perform a sector-by-sector scan for bad areas. The following list presents valid values for NTFS, FAT, and FAT32 UnitSize :įAT and FAT32 also support 128K and 256K for a sector size greater than 512 bytes. Default settings are strongly recommended for general use. If you do not specify UnitSize, it is chosen based on volume size. Specifies the allocation unit size to use on FAT, FAT32, or NTFS volumes. If you use a single format command to format more than one disk, all of the disks will be given the same volume label. Use the syntax /v: to prevent the prompt for a volume label. If you omit the /v command-line option or use it without specifying a volume label, format prompts you for the volume label after the formatting is complete. Floppy disks can use only the FAT file system. Specifies the type of the file system: FAT, FAT32, NTFS, or UDF. If you do not specify any of the following command-line options, format uses the volume type to determine the default format for the disk. Specifies the mount point, volume name, or drive letter (followed by a colon) of the drive that you want to format. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |